ARP 135-5402 ARP Main Stud Kits Shifters Installation is as simple as

Installation is as simple as removing the old cap and threading this one into place

Each shock uses a full 2

7-ohm primary resistance

preventing turbulence that can disturb mass air flow sensor readings

T-bolt clamps

ARP 135-5402 ARP Main Stud Kits Shifters Installation is as simple asThe ARP 135 5402 ARP Main Stud Kits reinforces the engine's lower end by providing consistent, repeatable main bearing cap clamping. These main studs prevent cap walk and main bearing bore distortion at elevated RPM where factory fasteners may allow crankshaft deflection and bearing clearance changes. Part 15266 is configured for its specific application with attention to fitment requirements. ARP main studs are machined from 8740 chromoly steel, heat